Dovre VINTAGE 35GA Installation Et Mode D'emploi page 60

6. Extend the facade sleeve through the facade from
the outside, with the "TOP" up, connect to the con-
centric elbow and attach it to the outside of the
facade (make sure the air intake cover drains to
the outside).
7. If so desired, the hole on the inside of the wall can
be finished with a wall plate.
Facade sleeve through facade of
flammable material
Read the "Installation Conditions" chapter care-
fully and follow the installation instructions
below.
1. Follow instruction steps 1 and 2 in the preceding
section.
2. Make a hole in the facade in such a way that the
sleeve is and remains at least 50 mm away from
flammable material all around. This can be done in
the following two ways; see the illustration below.
a. Use a protective duct (1) of non-flammable
material with a diameter of 250 mm.
b. Make a tube (2) of non-flammable material,
250 mm square.
Prevent dust and/or grit from getting into the
stove when drilling.
3. Follow instruction steps 4, 5 and 6 in the preceding
section.
4. Always use centering plates (3) to center and fin-
ish the facade sleeve.
Converting an existing flue
If the home already has a chimney, you can lead the
concentric duct system through the existing chimney
12
pipe. You can also convert the existing pipe into a con-
centric pipe using a single-wall flexible hose and the
right pipe reducers. There is a conversion kit for this.
See the chapter "Installation requirements" for the con-
ditions under which this conversion is permitted.
The conversion kit must be ordered separately.
The following parts are required to convert an existing
flue into a closed system; see next figure.
1 The hearth or stove to be connected
2 Concentric duct, 100/150 mm, modular
3 Installation plate inside, square 300 mm
4 Single-wall slide, round diameter 97 mm
5 Parker screws (4 pc)
Subject to change because of technical improvements
09-20020-194