Handling And Transportation; Assistance And Repairs; Warranty Coverage - EMAK KTK 102H Série Manuel D'utilisation

– protected from inclement weather
– covered with a sheet where
possible (par. 15.4)
– in a place where children cannot get to it
– making sure that keys or tools used
for maintenance are removed.
Before starting to use the machine again:
• check that there are no fuel leaks from
the tubes, fuel stopcock or carburettor:
• prepare the machine as described in
chapter "6. Using the machine" .

10. HANDLING AND TRANSPORTATION

• When handling the machine, always:
– disengage the cutting device;
– bring the cutting device assembly
to the highest position;
– stop the engine;
• When transporting the machine
on a vehicle or trailer, always:
– use an access ramp of suitable
strength, width and length;
– load the machine with the engine
switched off, with the key removed from
the ignition, without a driver and pushed
by an adequate number of people;
– close the fuel tap (if provided);
– lower the cutting -device assembly;
– engage the parking brake;
– position it so that it does not
cause a hazard to anyone;
– fasten firmly to the device of transport using
ropes or chains to prevent it from tipping
over causing damage and fuel leaks.

11. ASSISTANCE AND REPAIRS

This manual provides all the necessary
information to run the machine and for correct
basic maintenance operations which can
be performed by the user. Any regulations
and maintenance operations not described
herein must be carried out by your Dealer
or Authorised Service Centre, which have
the necessary knowledge and equipment to
ensure that the work is carried out correctly,
maintaining the correct degree of safety and the
original operating conditions of the machine.
Any operations performed in unauthorised
centres or by unqualified persons will totally
invalidate the Warranty and all obligations
and responsibilities of the Manufacturer.
• Only Authorised Service Centres can carry
out guaranteed repairs and maintenance.
• Non-original parts and attachments are
not approved; use of non-original spare
parts and attachments will jeopardise
the safety of the machine and relieve the
Manufacturer from all obligations or liabilities.
• Genuine spare parts are supplied by
Authorised Assistance Centres and Dealers.
• It is advisable to send your machine
once a year to an Authorised Service
Centre for servicing, assistance
and safety device inspection.

12. WARRANTY COVERAGE

The warranty covers all material and
manufacturing defects. The user must
follow all the instructions provided in
the accompanying documentation.
The warranty does not cover
damages caused by:
• Failure to become familiar with the
documentation accompanying the machine.
• Carelessness.
• Incorrect or prohibited use or assembly.
• Use of non-genuine spare parts.
• Use of attachments not supplied or
approved by the manufacturer.
The warranty does not cover:
• Normal wear and tear of consumables,
such as drive belts, headlights, wheels,
blades, safety bolts and wires.
• Normal wear and tear.
• Engines. Engines are covered by
the warranty provided by the relative
manufacturer in compliance with the
specified terms and conditions.
The purchaser is protected by his own national
legislation. The purchaser's rights envisaged
by the national laws in his own country are
not in any way restricted by this warranty.
EN - 26