Type "Ii" Display And Buzzers; Operating Functions - EMAK KTK 102H Série Manuel D'utilisation

Indicator light ON: when the engine
is running there are battery re-
charging faults (Fig. 16.G).
Flashing indicator light before start-
up: the battery is unable to start
the engine. Contact an Authorized
Service Centre (Fig. 16.G).
Indicator light ON: transmission
in "neutral" (Fig. 16.H).
• Acoustic signals - Buzzer
There are two types of acoustic signal:
1. Continuous • Electronic card protection
acoustic signal:
• The engine has been
2. Intermittent • The grass catcher is full.
acoustic signal:

5.17 TYPE "II" DISPLAY AND BUZZERS

When the key is turned to the «ON» position,
all the icons switch on for about half a second
(accompanied by a short acoustic signal)
to indicate that they function correctly, then
the display goes into "Timer" mode.
Thereafter, these lights indicate:
Indicator light ON: cutting
devices engaged (Fig. 16.A).
Indicator light ON: parking
brake engaged (Fig. 16.B).
Indicator light ON: operator
not present (Fig. 16.C).
Simple fuel indicator light (Fig. 16.D).
Flashing indicator light: fuel is in reserve.
system has intervened.
switched off for more than
30 seconds with the key
in the "DRIVE" position.
Fuel indicator light with level
indicator (Fig. 16.D).
The indicator light shows the fuel level in the
tank in accordance with the following criteria:
Fuel level is between full
and about half full.
Fuel level is between half full and reserve.
Fuel level is in reserve.
NOTE The reserve tank holds
approximately 2 litres of fuel, which is
sufficient for operating the machine for 30-
40 minutes at nominal engine speed.
Flashing indicator light: engine
lubrication faults (Fig. 16.E). Stop
engine immediately, check oil level and
contact an Authorized Service Centre.
Indicator light ON: Grass catcher or rear
discharge guard missing (Fig. 16F) (only
for models with rear grass catcher);
Indicator light ON: when the engine
is running there are battery re-
charging faults (Fig. 16.G).
Flashing indicator light before start-
up: the battery is unable to start
the engine. Contact an Authorized
Service Centre (Fig. 16.G).
Indicator light ON: transmission
in "neutral" (Fig. 16.H).

• Operating functions

Press the "MODE" button to access
operating functions in sequence.
Hour meter (Fig. 16.I). Indicates the total
number of engine operating hours.
Voltmeter (Fig. 16.O). Indicates
the battery charge state.
Tachometer (Fig. 16.K) Indicates the
engine speed as numerical values or a
series of asterisks, corresponding to:
EN - 13