Using The Machine; Preparation; Seat Adjustment; Tyre Pressure - EMAK KTK 102H Série Manuel D'utilisation

Battery icon with level indicator (Fig. 16.G).
Icon ON: Battery is charging.
Icon ON: Battery voltage level is optimal.
Icon on with engine off: Indicates
that the battery needs re-charging
Icon on with engine on: Indicates
battery charging problems.
Flashing icon: The battery is unable
to start the engine. You must contact
an Authorized Service Centre.
Icon ON: transmission in
"neutral" (Fig. 16.H).
Hour meter (Fig. 16.I). Indicates the total
number of engine operating hours.
Headlights (Fig. 16.P). Icon ON:
Indicates that the headlights are on.
Maintenance required (Fig. 16.Q).
Icon ON: Routine maintenance
indicator. The maintenance schedule
to follow is described in section
13. The icon comes ON every 50
hours and remains ON for 1 hour.
Green Area (Fig. 16.R). The
engine rotation speed is suitable
for optimal grass cutting.
• Acoustic signals - Buzzer
There are two types of acoustic signal:
1. Continuous • Electronic card protection
acoustic signal:
• The engine has been
2. Intermittent • The grass catcher is full.
acoustic signal:
system has intervened.
switched off for more than
30 seconds with the key
in the "DRIVE" position.

6. USING THE MACHINE

The safety regulations to follow
are described in chap. 2. Strictly
comply with these instructions to
avoid serious risks or hazards.

6.1 PREPARATION

Before starting to mow, it is necessary to carry
out several checks and operations to ensure you
can work efficiently and in maximum safety.
1. ensure the machine is level and
resting safely on the ground:
2. select the appropriate operating
mode (par. 6.1.4);
6.1.1 Filling with oil and fuel
IMPORTANT The machine is
supplied without engine oil or fuel.
Before using the machine check for fuel and
the oil level (par. 7.2, par. 7.3). For refuelling
and oil top-up methods and precautions
follow the instructions given in (par. 7.2,
par. 7.3) and in the engine handbook.

6.1.2 Seat adjustment

The sliding seat may be set to one
of six different positions.
To adjust it, lift the handle (fig. 17.A), slide
the seat and lock it in the desired position.

6.1.3 Tyre pressure

Having the right tyre pressure is the main
condition for ensuring that the cutting device
assembly is horizontal and mows evenly.
1. Unscrew the valve caps
2. Connect a compressed air line with
a gauge to the valves (fig. 18)
3. Adjust the pressure according to the values
indicated in the "Technical Data" chart.
6.1.4 Preparing the machine
before starting work
NOTE This machine can be used to
mow lawns in a number of different ways;
before starting work, prepare the machine
based on how the lawn is to be mowed.
a. Preparation for grass cutting and
collection in the grass catcher (for
rear collection models only)
EN - 15