Lenze EMZ9371BC Instructions De Mise En Service page 112

8 Parameterisation 9300 series
Transmit parameter sets
Step
6. Select the correct copy function
l
Copy all parameter sets available into the
EEPROM of the standard device and save them
permanently.
l
Copy individual parameter sets into the main
memory of the standard device.
7. Start copying
8.
Change to the code level
112
Key sequence
z
z
T V
V
A
V
B
l
Action
The settings saved in the standard device
are overwritten.
l
The parameter set that was active
before copying is overwritten.
l
The parameters are not yet active
after copying. Select parameter set
and load it in the main memory.
^ 108
Set "20" "ext −> EEPROM"
Copy parameter set 1 into the main
memory:
ð
Set "11" "Load ext PS1"
Copy parameter set 2 into the main
memory:
ð
Set "12" "Load ext PS2"
Copy parameter set 3 into the main
memory:
ð
Set "13" "Load ext PS3"
Copy parameter set 4 into the main
memory:
ð
Set "14" "Load ext PS4"
The "RDY" status display goes off. As
parameter value "BUSY" is displayed.
If "BUSY" goes off, the parameter sets
selected were copied into the standard
device. The "RDY" status display is lit.
Display of the operating level
Display C0002 and "PAR LOAD"
EDK9371BC DE/EN/FR 3.1