Lenze EMZ9371BC Instructions De Mise En Service page 97

Main menu
No. Display
EDK9371BC DE/EN/FR 3.1
Parameterisation 8200 vector/8200 motec
Submenus
No. Display
5.21 Torque−Ctrl 7
5.21.1 FIF managem
5.21.2 Torque setpt
5.21.3 f limit
5.21.4 Motor param
5.21.5 Motor ident
Process control with PID controller in the "V/f characteristic control"
operating mode
5.22 PID−Ctrl 0
5.22.1 Setpoint
5.22.2 Actual value
5.22.3 PCTRL setup
5.22.4 f limit/ramp
5.22.5 Motor param
5.23 PID−Ctrl 1
5.23.1 Setpoint
5.23.2 Actual value
5.23.3 PCTRL setup
5.23.4 f limit/ramp
5.23.5 Motor param
l
Menu structure
Description Description
Operation with the fieldbus function
module on FIF (DRIVECOM control)
Torque setpoint via process data
channel
Speed limitation via process data
channel
Set up fieldbus communication
Torque setpoint configuration
Speed limitation configuration
Motor current control and motor
monitoring configuration
Motor parameter identification
Setpoint via parameter channel
(C0181)
Analog selection of actual value via
analog input 1 (AIN1)
Setpoint configuration
Actual value configuration
Process controller configuration
Output frequency, acceleration time
and deceleration time configuration
Motor current control and motor
monitoring configuration
Setpoint via parameter channel
(C0138)
Analog selection of actual value via
analog input 1 (AIN1)
Setpoint configuration
Actual value configuration
Process controller configuration
Output frequency, acceleration time
and deceleration time configuration
Motor current control and motor
monitoring configuration
7
97