Lenze EMZ9371BC Instructions De Mise En Service page 77

7 Parameterisation 8200 vector/8200 motec
Change and save parameters
All parameters for controller setting or monitoring are saved in codes. The codes are
numbered and labelled in the documentation with a "C". Some codes store the parameters
in numbered subcodes", so that a clear parameter setting is ensured (e. g.: C0517 User
menu).
The codes are described in detail in the system manual of the drive controller.
)
Note!
The settings made in the menus are always saved to parameter set 1.
Two menus can be used to save settings to the parameter sets 2, 3, or 4:
"Code list" in menu 2 provides direct access to all available codes.
ƒ
Using "Param managm" in menu 7, parameter set 1 can be copied to all
ƒ
other parameter sets.
– Please note that your own basic settings will be overwritten by the
settings of parameter set 1 during the process of copying!
EDK9371BC DE/EN/FR 3.1
Parameterisation 8200 vector/8200 motec
l
Change and save parameters
7
77