Ascend S2 Manuel D'utilisation page 11

ASSEMBLY INSTRUCTIONS
STEP 3
1. First, identify the front (15) and rear (12) stabilizers. The front stabilizer has two wheels,
while the rear stabilizer does not.
2. Next, attach two large stabilizer legs (25) to each end of the rear stabilizer (12) and one
small stabilizer leg (26) in the middle. Repeat this process for the front stabilizer (15).
Have one person lift the back of the bike frame (16), while the other person positions the
back rear stabilizer (12) in its designated space.
3. Secure it in place by inserting and tightening two socket head screws (14) with two flat
washers (11) and two cap nuts (10). You'll need an Allen wrench (2) and an open-end wrench
(4) for this task.
4. Finally, carefully lay the bike back down on the floor.
With one person lifting the front of the bike frame (16), the other person should position the
front stabilizer (15) in its designated space.
Secure it by inserting and tightening two hex button head screws (14). You'll need an Allen
wrench (2) for this part.
5. Afterward, gently lay the bike back down on the floor.
To level the bike, adjust the stabilizer legs (25 and 26) by turning them clockwise to lower the
bike and counterclockwise to lift it. Make sure they all touch the floor.
11
S2 MAGNETIC SPINNING BIKE