Maintenance; Filter Replacement; Compressor Pump Oil Change - Ingersoll Rand SS3 Manuel Du Propriétaire

EN
Disconnect wire from engine spark plug and release
air pressure from the tank before performing

maintenance

NOTICE
All compressed air systems contain maintenance
parts (eg lubricating oil, filters, separators) which are
periodically replaced These used parts may be, or may
contain, substances that are regulated and must be
disposed of in accordance with local, state, and federal
laws and regulations
NOTICE
Take note of the positions and locations of parts
during disassembly to make reassembly easier The
assembly sequences and parts illustrated may differ
for your particular unit
NOTICE
Follow engine owner's manual for engine maintenance
schedules and procedures
NOTICE
Any service operations not included in this section
should be performed by an authorized service
representatives
PERIOD
Check lubricant level. Fill as needed.
Drain receiver tank condensate.
Open the manual drain valve
and collect, dispose condensate
accordingly.
Daily or before each
Check for unusual noise and
vibration.
operation
Ensure beltguards and covers are
securely placed.
Ensure area around compressor is
free from rags, tools, debris, and
flammable or explosive materials.
Inspect air filter element. Clean/
Replace if necessary.
Inspect for air leaks. Squirt soapy
water around joints during
Weekly/Monthly
compressor operation and watch for
bubbles.
Check tightness of screws and bolts.
Tighten as needed.
Clean exterior.
Change petroleum lubricant while
crankcase is warm.
Petroleum - 3/500*
Synthetic - 12/2000*
Change synthetic lubricant while
crankcase is warm.
Replace filter element.
* - indicates months/operating hours, whichever occurs first
EN-10
RELEASED 16/Apr/2018 18:50:16 GMT
MAINTENANCE
WARNING
MAINTENANCE
„ FILTER REPLACEMENT
1. Unscrew and remove the wing-nut (A).
2. Remove the filter cover (B), baffle (C) and element (D)
from the base (E).
3. Install a new element and reassemble the filter assembly.
The air intake holes in the baffle and cover must be
staggered 180° When reinstalling the assembly at the
inlet connection, ensure the intake hole in the cover is
on the bottom to minimize the entry of foreign matter
from the air
B
A
„ COMPRESSOR PUMP OIL CHANGE
1. Remove the oil drain plug (A) and allow the lubricant to
drain into a suitable container.
2. Replace the oil drain plug.
3. Follow the filling procedures in OPERATION section.
NOTICE
E
D
C
A
22204911 Rev. D