Compressor Lubrication; Synthetic Compressor Lubricant; Alternate Lubricants; Compressor Pump Filling Procedures - Ingersoll Rand SS3 Manuel Du Propriétaire

EN
„ COMPRESSOR LUBRICATION
Do not operate without lubricant or with inadequate
lubricant Ingersoll Rand is not responsible for
compressor failure caused by inadequate lubrication

SYNTHETIC COMPRESSOR LUBRICANT

„
Ingersoll Rand recommends All Season Select synthetic
lubricant from start-up. See the WARRANTY section for
extended warranty information.

ALTERNATE LUBRICANTS

„
You may use XL-300 or a comparable petroleum-based
lubricant that is premium quality, does not contain
detergents, contains only anti-rust, anti-oxidation, and anti-
foam agents as additives, has a flashpoint of 440°F (227°C)
or higher, and has an auto-ignition point of 650°F (343°C) or
higher.
See the petroleum lubricant viscosity table below. The table
is intended as a general guide only. Heavy duty operating
conditions require heavier viscosities. Refer specific operating
conditions to Ingersoll Rand for recommendations.
Temperature
Viscosity @ 100°F
Around
Compressor
°F °C SUS
< 40 < 4.4 150
40-80 4.4-26.7 500
80-125 26.7-51.0 750
If you use a petroleum-based compressor lubricant at start-
up and decide to convert to All Season Select later on, the
pump must be decarbonized and flushed before conversion.
Contact Ingersoll Rand for more information.
EN-8
RELEASED 16/Apr/2018 18:50:16 GMT
INSTALLATION
CAUTION
Viscosity
(378°C) Grade
Centistokes ISO SAE
32 32 10
110 100 30
165 150 40

COMPRESSOR PUMP FILLING PROCEDURES

„
1. Unscrew and remove the oil fill plug (A).
2. Slowly fill the crankcase with lubricant until the lubricant
reaches the bottom thread of the oil fill opening and the
top of the sight glass.
Note: SS3 Crankcase capacity is one (1) pint (0.5 liters).
3. Replace the oil fill plug HAND TIGHT ONLY.
Full
Add

ENGINE LUBRICATION AND FUEL

„
Do not operate without lubricant or with inadequate
lubricant Ingersoll Rand is not responsible for engine
failure caused by inadequate lubrication
Refer to the engine operator's manual provided with the unit
for engine lubrication and fuel requirements.
A
CAUTION
22204911 Rev. D