Model Assembly (Continued); Battery Installation And Esc Arming - Horizon Hobby E-FLITE Turbo Timber Evolution 1.5m Manuel D'utilisation

EN

Model Assembly (continued)

Wing Installation (continued)
3. Insert the connectors from the wings into the sockets on the fuselage.
4. Insert the leading edge of the wing into the wing saddle, and then tighten the
M6 x 30mm nylon wing screws to secure the wing in place.
CAUTION: DO NOT crush or otherwise damage the wiring when attaching
the wing to the fuselage.
Disassemble in reverse order.

Battery Installation and ESC Arming

The Spektrum Smart 3200mAh 4S 30C Li-Po battery (SPMX32004S30) is
™
recommended for best performance.
Refer to the Optional Parts List for other recommended batteries. If using a
battery other than those listed, the battery should be within the range of capacity,
dimensions and weight of the Spektrum Li-Po battery pack to fit in the fuselage.
Be sure the model balances at the recommended CG before flying.
WARNING: Always keep hands away from the propeller. When armed, the
motor will turn the propeller in response to any throttle movement. If your
transmitter supports it, always engage throttle cut before approaching the aircraft
any time a battery is connected.
1. Lower the throttle and throttle trim to the lowest settings. Power on the
transmitter, then wait 5 seconds.
2. Lift up on the rear of the hatch up to remove the hatch from the fuselage.
3. Install the fully charged battery in the battery compartment, as shown. Secure
using the two included hook and loop straps.
4. Connect the battery to the ESC (the ESC is now armed).
5. Keep the aircraft immobile and away from wind or the system will not initialize.
• The ESC will sound a series of tones.
• An LED will light on the receiver.
• If the ESC sounds a continuous double beep after the flight battery is
connected, recharge or replace the battery.
6. Reinstall the canopy hatch.
10
Turbo Timber Evolution 1.5m