Transporting By Trailer; Machine Storage; First Period Of Use - Nilfisk Advance RS 501 Instructions D'utilisation

Masquer les pouces Voir aussi pour Advance RS 501:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

ENGLISH

TRANSPORTING BY TRAILER

To transport the machine with a trailer, use the hooks and anchors shown below.
WARNING!
Machine anchorage must be performed by qualifi ed personnel.
Available hooks
The machine is equipped with the following hooks:
No. 1 front towing/anchor hook (1, Fig. B).
No.1 rear anchor hook (2, Fig. B).
Anchorage
To anchor the machine in case of transport by trailer, proceed as follows:
Set the machine to transport mode (see the procedure in the relevant paragraph).
Remove the ignition key (17, Fig. D).
Engage the parking brake (7, Fig. E).
Close all doors, panels, etc.
Anchor the machine with the front and rear towing hooks (1 and 2, Fig. B).
Anchor the machine with two suitable bands (4 and 5, Fig. B), placed over the rear axle support (6), and on the front left and
right cab footboards (3) respectively.

MACHINE STORAGE

If the machine is not going to be used for more than 30 days, proceed as follows:
1.
Empty the dust control system water tanks according to the following procedure.
2.
Prepare the machine, as shown in the After Machine Use paragraph.
3.
Store the machine indoor, in a clean and dry place, protected from bad weather conditions and with the following values:
Temperature: +1 °C to +50 °C
Humidity: max. 95%
4.
Disconnect the negative connector from the battery (18, Fig. E).
5.
Handle the diesel engine as shown in the relevant Manual.
WARNING!
When the machine is to be transported or stored at ambient temperatures below 0 °C, check that water tanks are
empty, disassemble and drain the water fi lter housing.

FIRST PERIOD OF USE

After the fi rst period of use (fi rst 8 hours) it is necessary to perform the following procedures:
Check the fastening and connecting elements for proper tightening. Check the visible parts for integrity and leaks.
After the fi rst 50 working hours, perform checks and replacements shown in the Scheduled Maintenance Table.
28
INSTRUCTIONS FOR USE
33019745(2)2009-12
RS 501

Publicité

Table des Matières
loading

Table des Matières