Using The Windscreen Wiper/Washer; Using The Cab Heating; Using The Cab Climate Control System (*); Lighting System Operation - Nilfisk Advance RS 501 Instructions D'utilisation

ENGLISH

USING THE WINDSCREEN WIPER/WASHER

1. Press the switch (20, Fig. D) to sprinkle the detergent on the windscreen.
2. Press the switch (20, Fig. D) to start and stop the windscreen wiper.

USING THE CAB HEATING

1. Turn the ignition key clockwise and hold it in the fi rst position.
2. To turn on the cab heating, turn the knob (15, Fig. E) counterclockwise as necessary.
3. Choose one of the two blower speed with the switch (21, Fig. D).
4. To turn off the cab heating, turn off the blower with the switch (21, Fig. D) and turn the knob (15, Fig. E) clockwise to the end of
stroke.

USING THE CAB CLIMATE CONTROL SYSTEM (*)

(*) Optional
1. Start the engine as shown in the relevant paragraph.
2. Start the cab fan as shown in the relevant paragraph.
3. Turn on the climate control system by pressing the lower part of the switch (18, Fig. D).
4. To turn off the climate control system, turn the switch (18, Fig. D) to the original position.

LIGHTING SYSTEM OPERATION

To turn on the lighting and signalling system, use the combination switch (1, Fig. E), having the following functions:
– Headlights off, with mark (1b) at the symbol O
– Running lights on, with mark (1b) at the symbol
To turn on the running lights the ignition key must be turned clockwise and held in the fi rst position.
– Low beam on, with mark (1b) at the symbol
To turn on the low beam, the engine must be running.
– High beam on, with mark (1b) at the symbol
To turn on the high beam, the engine must be running.
– High beam temporary on, lifting the lever (1a).
To turn on the high beams temporarily, the ignition key must be turned clockwise and held in the fi rst position.
– Right turn signal on, bringing the lever (1a) forward.
To turn on the turn signals the ignition key must be turned clockwise and held in the fi rst position.
– Left turn signal on, bringing the lever (1a) backward.
To turn on the turn signals the ignition key must be turned clockwise and held in the fi rst position.
– Horn activation, pushing the lever (1a) in the direction shown by the arrow (1c).
The horn activates also when the key is turned to on.

WORKING LIGHT OPERATION

Turn on the working lights with the switch (13, Fig. D), after turning on the low beams.
The working lights do not turn on if the high beams are already turned on.

HAZARD WARNING LIGHT OPERATION

Turn on the hazard warning lights with the switch (22, Fig. D).
The hazard warning lights can be turned on even if the ignition key is turned to off.

CAB COURTESY LIGHT OPERATION

Turn on the ceiling light (30, Fig. D) with the switch (31).
The courtesy light can be turned on even if the ignition key is turned to off.
24
INSTRUCTIONS FOR USE
.
.
and lowered lever (1a).
33019745(2)2009-12 RS 501