Using The High-Pressure Water Gun (*); Using The Camera Kit (Optional) - Nilfisk Advance RS 501 Instructions D'utilisation

ENGLISH

USING THE HIGH-PRESSURE WATER GUN (*)

(*) Optional
The machine is equipped with a high-pressure water system (optional) to be used for washing the machine or other purposes.
WARNING!
The machine is equipped with a safety system that deactivates or does not allow for the activation of the high
pressure pump if the water level in the tanks is insuffi cient for an interval of 10 seconds or more.
The following procedure refers to the high-pressure water gun use.
1. Release the fasteners (37, Fig. G) and open the upper rear hood (36).
2. Pick up the high-pressure water gun (39, Fig. G).
3. Withdraw part of the hose (26, Fig. G) and connect the gun (39) to the quick coupling (27).
4. If necessary, remove the sprinkler nozzle (30, Fig. E) and screw it to the water gun end (39, Fig. G).
5. Engage the parking brake (7, Fig. E).
CAUTION!
This condition is signalled by the rear brake lights fl ashing for 30 seconds.
In this condition, the engine can be started even if the operator is not on the driver's seat.
NOTE
When key is turned to on, if the operator leaves the driver's seat, an intermittent warning buzzer signals that the parking
brake is disengaged.
6. Start the diesel engine at idle speed, as shown in the relevant paragraph.
7. Turn on the high-pressure pump with the lever (14, Fig. E).
8. If necessary, bleed the air from the system by turning the water gun knob completely counter-clockwise and by pressing the
water gun lever until the water comes out constantly and at low pressure.
Release the water gun lever and turn the knob clockwise to use the high pressure nozzle.
9. Run the engine at the desired speed (do not exceed 2,200 rpm).
10. Check the water pressure with the pressure gauge (32, Fig. G).
11. Use the water gun by pressing the relevant trigger.
WARNING!
Protect body parts (eyes, hair, hands, etc.) properly, when performing cleaning procedures using compressed
air or water gun.
WARNING!
Do not run the high pressure pump for long periods without using the water gun.
12. After using the water gun, perform steps from 1 to 5 in the reverse order.

USING THE CAMERA KIT (optional)

The video-camera system can be turned on manually or automatically with the drive pedal.
1. Manual activation
• When the machine is in "neutral" (drive pedal not pressed), to turn on the video system (35, Fig. F) and the camera (34),
press the switch (37) when the ignition key (17, Fig. D) is inserted.
The display shows the images received from the rear camera.
2. Automatic activation
• When the ignition key (17, Fig. D) is inserted, the video (35, Fig. F) and the camera (34) turn on when pressing the drive
pedal.
The display shows the images received from the rear camera when the drive pedal is either in forward or reverse gear.
3. For the functions of other switches on the display, refer to the camera kit Manual.
26
INSTRUCTIONS FOR USE
33019745(2)2009-12 RS 501