CF MOTO CFORCE 1000 Guide De L'utilisateur page 186

VEHICLE DIAGNOSIS
EPS Malfunction Indicator Light
The Electronic Power Steering system (1) on your vehicle contains a self-diagnostic feature that will
illuminate the malfunction indicator light (MIL-2) if it detects a problem. In normal operation, the EPS indicator
will be on after the ignition switch is turned to ON, but EPS will not work. When the engine is started, the EPS
indicator will be off and the EPS starts to function.
1
O O P P C C
2
Trouble Code
Each trouble code consists of 2 digits,denoted by the times of long flash and short flash of EPS indicator.
Times of long flash represent the tens digit;
Times of short flash represent the single digit;
Duration of long flash: 2 sec.
Duration of short flash: 1 sec.
Flash interval: 1 sec.
The flash cycle will repeat after EPS indicator turns off for 3 seconds. Write down the flash sequence and
contact your dealer for diagnosis. Your dealer has the special tool required to diagnose, repair and clear
trouble codes. Any codes will disappear once the problem has been diagnosed and repaired by your dealer.
182