CF MOTO CFORCE 1000 Guide De L'utilisateur page 142

Gear case oil
The front and rear gear cases should be checked for oil leaks and
correct oil level before each ride. If a leak is found, contact your
dealer for repair�
Rear gear oil measurement
Because of is unique design, draining and filling the rear gear case is
required to produce the correct oil level. Refer to "Rear gear case oil
change".
Rear gear case oil change
1� Place the vehicle on a level surface.
2� Place a container under the rear gear case to collect the used oil.
3� Remove oil filler bolt
used oil.
4� Install and tighten drain bolt to the specified torque.
5� Add recommended amount of gear oil into the rear gear case.
6� Install and tighten filler bolt to the specified torque after adding
new gear oil�
7� Check for oil leaks. If leakage is found, find and repair it.
NOTE:
Drain bolt torque: 25N•m (18.4 ft-lb.)
Periodic oil change: 400 ml (13.5 oz)
NOTE: Be sure no foreign material enters the gear case.
MAINTENANCE
and drain bolt as shown and drain
1 2
138
1
2