CF MOTO CFORCE 1000 Guide De L'utilisateur page 145

Changing the coolant
CAUTION
After stopping the engine, do not remove cap of radiator
immediately� Wait for a while to cool down the coolant and then
remove radiator cap. Hot coolant can cause serious burns.
1� Place the ATV on a level surface.
2� Remove the front access cover�
3� Remove the radiator cap�
4� Remove the coolant reservoir cap�
5� Place a container under the engine, and then remove:
▪ The left engine cover�
▪ The coolant drain bolt
object to prevent coolant from spilling on the footrest.)
6� Disconnect the hose on the coolant reservoir side, and then
drain the coolant from the coolant reservoir�
7� After draining the system, thoroughly flush the cooling system
with clean tap water� Allow the water to drain completely from
the coolant drain�
8� Replace the coolant drain bolt washer if it is damaged, and
then tighten the coolant drain bolt, but do not torque to
specification.
MAINTENANCE
. (Use a trough or a similar
1
141
1