Publicité
Les langues disponibles
Les langues disponibles
Risk of crushing at the closing edges
While the gate is moving, limbs and fingers may be pinched or crushed
between the gate and the main closing edge and the secondary closing edges!
SAFETY WARNINGS FOR HAZARD AVOIDANCE
• Do not touch the main or secondary closing edges while the door is
moving.
•
Ensure that children do not touch the main or secondary closing edges
while the door is moving.
Danger of crushing on the gear rack
During gate travel, limbs and fingers may be pinched or crushed between the
gear and the rack!
SAFETY WARNINGS FOR HAZARD AVOIDANCE
• Do not touch the gear or rack while the gate is moving.
• Ensure that children do not touch the gear wheel or gear rack during the
gate movement.
21.2. Setting the control unit
The electrical connection must be made according to the enclosed control
instructions "47-21-0" (optionally "47-21-i").
• The 8-pin dip switch of the control unit 47-21-0 is used to activate special
functions of the motor control unit. It is not a coding switch for the radio.
• The gate requires a mechanical end stop in the end positions "OPEN"
and "CLOSED" so that the gate cannot run out of the guide in case of a
fault.
WARNING
WARNING
NOTE
31
Publicité
