Publicité
Les langues disponibles
Les langues disponibles
1 1 3 3 . . S S e e t t t t i i n n g g u u p p t t h h e e d d r r i i v v e e p p o o r r t t a a l l / / d d r r i i v v e e p p o o r r t t a a l l 8 8 0 0 0 0 i i
Make sure that the portal does not fall over until you have fixed it to the
foundation.
Place the drive portal on the intended surface. The Drive gear should not yet
mesh with the rack. If necessary, lower the drive unit using the height adjuster.
(The motor and gear unit can be adjusted in height by approx. 200 mm.) The
emergency release must be set to "Unlocked".
Now align the operator exactly parallel to the door and fasten it to the
foundation or to the console in the Ground. (Through the slotted holes of the
mounting plate the drive can be readjusted a little bit).
Now the drive unit can be adjusted to the desired height with the help of the
height adjustment (only use a key, do not use a cordless screwdriver or similar).
1 1 4 4 . . I I n n s s t t a a l l l l a a t t i i o o n n o o f f t t h h e e d d r r i i v v e e p p o o r r t t a a l l
Fatal electric shock from mains voltage!
There is a risk of life-threatening / fatal electric shock on contact with the mains
voltage.
SAFETY INSTRUCTIONS FOR HAZARD AVOIDANCE
• Electrical connections may only be carried out by a qualified electrician.
• When laying the power line, the applicable regulations must be observed
and complied with (IEC 364-4-41).
• Before carrying out any work, disconnect the system from the power
supply. Secure the system against unauthorized restarting of the system.
• Ensure that the on-site electrical installation complies with the relevant
protection regulations.
• To avoid hazards, a damaged mains connection cable must be replaced
by a qualified electrician with an undamaged mains connection cable.
• Use protective equipment during installation.
• The power supply (usually 230 V) must match the rating plate.
NOTE
DANGER
21
Publicité
