Publicité
Les langues disponibles
Les langues disponibles
All other connections are pre-wired in the portal or pre connected to each other
by plugs.
• Mains supply all-pole (by inserting the earthed plug into the earthed
socket)
• Radio transmission system for the moving main closing edge
• Through beam light barrier (receiver)
• 2 key switches with impulse function
• 1 emergency stop (inside)
• 4 safety contact strips (secondary closing edges)
•
Safety contact strip on the main closing edge (wired with radio
transmitter)
1 1 2 2 . . R R e e q q u u i i r r e e m m e e n n t t s s f f o o r r t t h h e e f f o o u u n n d d a a t t i i o o n n
A loss of the stability of the drive reduces the safety of the entire system. An
unsafe foundation can lead to the drive tipping over / breaking out or sinking.
This can cause personal injury and damage to property.
SAFETY INSTRUCTIONS FOR HAZARD AVOIDANCE
• The ground for mounting the drive must be firm, stable and frost-free.
• The foundation must be of sufficient size to prevent it from erupting. For
the required dimensions, refer to the manufacturer's dimensional
specifications.
• The drive must be correctly aligned with the door run
• The foundation must be sufficiently hardened before mounting the
drive!
A concrete foundation or steel construction of at least 800 x 500 mm is
required for the drive portal / drive portal 800i, and a concrete foundation or
steel construction of at least 400 x 300 mm, each at a frost-free depth (in
Germany = min. 80 cm deep), is required for the entry post.
ATTENTION
An unsafe foundation can cause damage!
19
Publicité
