Built-In Installation (For The Integrated Model) - FAR LVI1120 A++49M Manuel D'utilisation

ENGLISH
Underneath existing work top
(When fitting beneath a
work top) In most modern
fitted kitchens there is only
one single work top under
which cabinets and electrical
appliances are fitted. In this
case remove the work top of
the dishwasher by unscrewing the screws under
the rear edge of the top (a).
Attention
After removing the work top, the screws must be
screwed again under the rear edge of the top (b).
The height will then be reduced to815 mm,
as scheduled by the International Regulations
(ISO) and the dishwasher will fit perfectly under
the kitchen working top

Built-In Installation (for the integrated model)

Step 1. Selecting the best location for the
dishwasher
The installation position of dishwasher should be
near the existing inlet and drain hoses and power
cord.
GB-26