FAR LVI1120 A++49M Manuel D'utilisation page 109

ENGLISH
Rotate the adjusting screw to drive the adjustor
to strain or relax the steel cable.
2. Door spring tension is correct when the
door remains horizontal in the fully opened
position, yet rises to a close with the slight
lift of a finger.
Step 4. Dishwasher installation steps
Please refer to the specified installation steps
in the installation drawings.
1. Affix the condensation strip under the
work surface of cabinet. Please ensure the
condensation strip is flush with edge of work
surface. (Step 2)
2. Connect the inlet hose to the cold-water
supply.
3. Connect the drain hose.
4. Connect the power cord.
5. Place the dishwasher into position. (Step 4)
6. Level the dishwasher. The rear foot can be
adjusted from the front of the dishwasher by
turning the Philips screw in the middle of
the base of dishwasher use a Philips screw.
To adjust the front feet, use a flat screwdriver
GB-30