Chloride Power Protection Linear Plus Manuel D'utilisation page 50

Operating the Device
Danger
As soon as the UPS is connected to the AC mains, the output sockets
are live, even if the UPS is not yet switched on via the front panel switch.
Switch ON the mains supply to the UPS Linear Plus RM.
When connected to the mains, the "LINE" and "BYPASS" LEDs on the
control panel are illuminated and the UPS starts recharging the connected
(External) batteries immediately. Before using the device, the batteries
should be recharged for a period of 8 hours. The UPS may be used straight
away, even without charging, but will not be able to provide the specified
autonomy.
Once recharging has been completed the UPS is ready for use, follow
the UPS Start-Up Procedure - see "UPS start-up procedure Linear Plus
RM" on page EN-51.
Warning
Do not connect any devices that may overload the UPS or draw DC
current.
Note
If these instructions are not observed correctly, problems may be
experienced with the electrical supply.
EN-48
User Handbook
CHLORIDE LINEAR Plus/RM
SU59802UM01, rev.3/ Last modified: 08/2005