Chloride Power Protection Linear Plus Manuel D'utilisation page 5

CHLORIDE LINEAR Plus/RM
Safety
Intended use
This device serves as an uninterruptible power supply for connected loads.
The device is in compliance with all relevant safety regulations concerning
information technology equipment, including electronic machines for use in
an office environment.
Depending on the type and rating of UPS device, certain configurations of
battery extensions may be connected. These battery extensions may only
be connected to the compatible basic UPS unit.
This system, henceforward the "unit", serves as uninterruptible power
supply of connected loads, available as tower units or as rack for use in
19-inch industrial cubicles. The Linear Plus RM 6 kVA and 10 kVA must be
operated with at least one RM battery extension. These battery extensions
may only be connected electrically with the corresponding base UPS unit.
Warning
CHLORIDE considers the safety of personnel to be of paramount
importance. For this reason it is essential that procedures relating to
safety be studied before commencing work, and properly adhered to
thereafter.
• The User or Operator may intervene in the operation of the UPS
provided that the instructions laid out in "Batteries" on page EN-6,
"Control panel Linear Plus" on page EN-36 and "Indication and
Operating Elements Linear Plus RM" on page EN-43 are strictly
adhered to.
• The "Installation" of the UPS, described in "Installation" on page
EN-16, may only be carried out by qualified technical personnel.
• Even when all switches and interrupters are open, hazardous voltages
are present within the UPS; any operation that requires protection
panels to be opened and/or removed may be carried out by CHLORIDE
authorised technical personnel only.
The rack units listed in Table 1 on page EN-8 with a mounting height of 3 HU
(1 Height Unit = 44.45 mm) are designed for horizontal installation in 19-inch
cubicles of industrial standard.
User Handbook SU59802UM01, rev.3/ Last modified: 08/2005
Safety
E
N
EN-3