Publicité
Les langues disponibles
Les langues disponibles
1.2 Information for correct use of the product
CAUTION
Before starting the installation, re-check the mounting compatibility of the UC81 cylinder to the
motor consulting the attached "Application Guide" contained in the package.
WARNING
In any case do not make changes to the steering cylinder in order to make it better suit your
specific application. In this case the pump will not operate safely and endanger the boat and
its occupants.
The steering systems
maximum horsepower rating provided on site.
The UC81 cylinder is not recommended for installation on racing boats or boats with particularly low
dead-rise angle.
1.3 Configurations
The hydraulic cylinder UC81 must ONLY be installed on a steering system with a single outboard
motor and single steering station and ONLY used together with pump UP18 supplied in the GOTECH™
kit. The hydraulic cylinder UC81 is supplied in starboard configuration, i.e. with the extension arm
assembled on the starboard side; however, if correct installation is prevented by any element on the
boat, it can be assembled port side, i.e. with the extension arm on the left hand side.
STARBOARD CONFIGURATION
CAUTION
The UC81 hydraulic cylinder should not be mounted on boats with motor exceeding 115hp and / or
45mph (39kn).
For information on "port" configuration please refer to section 3.3 - "Installing the cylinder" of this
manual.
should not be used on boats equipped with engines that exceed the
HYDRAULIC CYLINDER FOR OUTBOARD MOTOR
Installation and Maintenance Manual
PORT CONFIGURATION
9
- page
Publicité
