Publicité
Les langues disponibles
Les langues disponibles
3.5.1 Positioning the oil bottle
The oil filler kit will be needed in order to carry out this operation (1 pin, 1 transparent pipe, 1 hose
carrier fitting and 1 oil bottle spout), NOT supplied as standard.
• Remove the cap from the pump and insert the filling adapter.
• Attach a nozzle to a new bottle of hydraulic oil, connecting the hose from the fill port to
the spout of the bottle.
• Turn the bottle and pierce it with a pin, as indicated in the figure, so as to facilitate the passage
of oil to the pump.
• Fill the pump until no air bubbles are no longer visible in the hose.
NOTE
At the time of oil bottles replacement, during
the filling process, close all bleed valves of
the cylinder.
To empty the system, make sure the filling
hose always contains oil. If during bleeding
air gets into the system, the whole process
must be repeated from the beginning.
NOTE
Replace the bottle before its emptying and do
not reuse the oil spilled from the system if not
after at least 24 hours.
Installation and Maintenance Manual
HYDRAULIC CYLINDER FOR OUTBOARD MOTOR
pin
oil bottle
flexible hose
33
- page
Publicité
