Publicité
Les langues disponibles
Les langues disponibles
WARNING
MOUNTING THE MOTOR TO THE TRANSOM WITH JACK PLATE.
The installation of a jack plate will change all of the clearances required for the application.
A new check of clearances must be completed with the rotation of the motor in conjunction with the
vertical movement of the jack plate in all possible positions. If the cylinder comes into contact with
the cockpit, transom, and / or the jack plate, immediately stop the installation!
Use the instructions of the jack plate manufacturer to limit the upper or lower direction in
which the interference occurs. If this is not possible, contact qualified staff.
3.2 REQUIRED TOOLS
Open end wrench
17 mm
Torque wrench
Wrench with 14
mm long socket
wrench
CAUTION
During the phases of installation only use stainless steel tools in order to avoid oxidation of
the metal parts.
Installation and Maintenance Manual
Open end wrench
14 mm
Allen wrench
4 mm
HYDRAULIC CYLINDER FOR OUTBOARD MOTOR
MOLYKOTE ® 1000
or
MARINE GREASE
Torx wrench T30
15
- page
Publicité
