Publicité
Les langues disponibles
Les langues disponibles
3.3 INSTALLATION OF THE CYLINDER
WARNING
Before proceeding with the installation of the product, ensure that you meet the requirements for
a correct application mentioned in section 1.3 - "Configurations" and 3.1 - "Cockpit minimum
requirements".
NOTE
is not liable for any damages caused by the contact between the cylinder and motor and/
or boat parts.
3.3.1 SWITCHING TO "PORT" CONFIGURATION
Here following is the description of the procedure required to reverse the position of the extension
arm in "port" configuration, if you want to mount the cylinder in a "starboard" configuration please
directly refer to section 3.3.2 - "Assembly of the cylinder."
CAUTION
Never remove the screw (A) to change the configuration of the cylinder.
NOTE
If switching from "starboard" to "port" configuration occurs after the first installation (e.g.
in case the motor is replaced), you must follow the procedure described AFTER you have
removed the cylinder and the related bullhorns.
CAUTION
Under no circumstances should the fastening screws on the heads (B) be dismantled more than
once. If a further change from port to starboard is necessary, or if gaskets need to be replaced, you
must buy the specific "change seals" kit.
Contact
support.
NOTE
To pass to port configuration, do not attach the label
16
page
-
CYLINDRE HYDRAULIQUE POUR MOTEUR HORS BORD
Installation and Maintenance Manual
unless at the end of the procedure.
Publicité
