Ultraflex UC 81 Manuel D'installation Et De Maintenance page 29

22
Tighten the screw (25) of the fine adjusting ring nut (26) with a torque of 3 Nm (2,2 lb ft).
23
Again check the correct movement of the motor during both left / right steering and during
the tilt-back rotation.
CAUTION
In this phase you must find a clearance sufficient to avoid friction, but not excessive so
as to cause the instability of the motor.
In case of contact with the transom suspend the installation and contact specialized staff.
3.4 Installation of tubes
The two fittings mounted on the cylinder body are already oriented and ready to be used.
WARNING
You cannot orientate the joints! Rotating them could compromise their correct functioning and
hydraulic seals.
Installation and Maintenance Manual
25
26
HYDRAULIC CYLINDER FOR OUTBOARD MOTOR
29
- page