SilverCrest SPM 2000 F3 Mode D'emploi page 12

Operation
1) Close the appliance lid using the handle 5.
2) Slide the juice collector 9 into the holder on the back of the appliance
(fig. 1).
Fig. 1
NOTE
In the front area of the dial 1, the marking shows you the set position.
►
3) Insert the plug into the mains power socket.
The indicator lamp 2 lights up.
4) Set the dial 1 to the desired position from "Min" to "Max".
The green indicator lamp 2 goes off and then lights up red:
The appliance heats up.
The red indicator lamp 2 goes off and then lights up green:
The set temperature has been reached. The appliance no longer heats up.
NOTE
When the indicator lamp 2 lights up red, this shows that the appliance is
►
heating up. The indicator lamp 2 remains switched on until the set
temperature level is reached. Note that, depending on the ambient
temperature, heating may start at different positions on the dial 1!
When the green indicator lamp 2 lights up green, this shows that the
►
appliance is no longer heating up. It therefore also lights up green when the
dial 1 is in any position before "Min".
The indicator lamp 2 may also change colour again after the set
►
temperature has been reached. The indicator light 2 then lights up red. This
indicates that the appliance is heating up again to maintain the temperature.
SPM 2000 F3
GB │ IE
│
9 ■