C.P.Bourg collators system AGR-P Manuel Opérateur page 41

TD/TD–T
The TD/TD–T automatically stacks (offset or straight) sets produced by the Bourg
Collator System. The machine interfaces with the Collator. On the Tower Collator
Systems only, the TD–T requires a separate electrical power connection. When the
TD/TD–T is full, it will automatically stop the collator from producing sets. The operator
must remove the finished sets and return the trolley to the upper position before
resuming production.
INSTALLATION
Position the TD/TD–T at the delivery end of the collator and secure it in place with the knurled
locking knobs. Connect the ten pin interface cable to the female receptacle in the collator. On
the TD-T only, plug the power cord into a properly grounded electrical wall outlet.
OPERATOR CONTROLS
1. MAIN POWER. (TD–T only). Located on the control panel on top of the TD-T the switch
will provide power to the TD-T and illuminate when turned "on".
2. EMERGENCY STOP.(TD–T only). Located on the control panel this switch will instantly
stop the TD-T and also stop the collator from producing sets. The operator must unlock
the switch by rotating the red knob slightly clockwise in order to restart both machines.
3. JOG SELECTOR. This toggle switch is on the control panel and is used to select the
straight or offset stacking mode.
4. MANUAL JOG. A push button on the panel enables the operator to cycle the jogging
arms.
5. TROLLEY RAISE. The push button will activate the trolley to raise. It is not necessary to
hold the button in, the table will stop automatically when fully raised.
6. TROLLEY LOWER. The push button will lower the trolley while the button is held in.
7. FUSES. (on the control panel). All fuses are slow blow type fuses.
Remember when replacing fuses always disconnect the power and use a properly
rated fuse.
8. BACKSTOP. The TD/TD–T has a moveable backstop to accommodate different lengths
of paper. Scales are provided for easy operator adjustment.
9. PAPER TROLLEY. The TD/TD–T comes with a removable paper trolley to allow the ope-
rator to wheel the collated sets away from the machine. Extra paper trolleys may be pur-
chased if required.
10. JOGGING ARMS. The TD/TD–T comes with different size jogging arms to handle the full
range of paper sizes for both straight or offset stacking.
11. LOWER SIDE GUIDES. The TD/TD–T comes with 2 non-operator and 3 operator lower
side guides to accommodate from the minimum to the maximum sheet sizes.
12. TROLLEY LOWERING CELL. The paper sensing cell on the backstop is adjustable up or
down to accommodate different set thicknesses.
36