Programming Of The Optional Functions; Intermediate Position "H" (Partial Opening/Closing); Rdc" Function (Drive Torque Reduction, On Closing Manoeuvre) - Nice Free-Max Instructions Et Avertissements Pour L'installation Et L'utilisation

PROGRAMMING OF
THE OPTIONAL FUNCTIONS
Important! – The optional functions can only be activated if positions "0"
and e "1" gave been programmed.
INTERMEDIATE POSITION "H"
6
(partial opening/closing)
✔
For AWNINGS: For ROLLER SHUTTERS:
Position "H" is an intermediate distance in which the roller shutter remains par-
tially open/closed.
Note – The roller shutter can be brought on the intermediate position, once
intermediate position "H" has been programmed, by pressing keys ▲ and ▼
simultaneously on the Transmitter.
Memorisation procedure of position "H"
01. Position the roller shutter into the required inter-
H
H
mediate position you wish to memorise by
pressing keys ▲, ■, ▼ on the transmitter.
02. Press and hold down key ■ (for approx. 5 sec-
(5")
onds), until the motor performs 1 VIBRATION;
1
then release the key.
03. Press and hold down again key ■ (for approx. 5
(5")
seconds), until the motor performs 4 SHORT
4
motions; then release the key.
04. Press and hold down keys ▲ and ▼simulta-
neously, until the motor performs 3 LONG
3
motions (= position "H" is memorised); then
release the keys.
Cancellation procedure of position "H"
(5")
(5")
✔
7
For AWNINGS:
The RDC function automatically reduces the drive torque of the motor by 50%:
this occurs during the closing manoeuvre just before the awning completely
closes against the box. Activating this function avoids excessive tension on the
fabric when the awning closes.
Activation procedure of the "RDC" function
(5")
(5")
(5")
01. Press and hold down key ■ (for approx. 5 sec-
onds), until the motor performs 1 VIBRATION;
1
then release the key.
02. Press and hold down key ■ again (for approx. 5
seconds), until the motor performs 4 SHORT
4
motions; then release the key.
03. Press and hold down keys ▼ and ▲ simultane-
ously (for approx. 5 seconds), until the motor
5
performs 5 LONG motions (= position "H" is
cancelled) then release the keys.
"RDC" FUNCTION (drive torque reduction,
on closing manoeuvre)
✔
For ROLLER SHUTTERS:
01. Press and hold down key ■ on the Transmitter
(for approx. 5 seconds), until the motor per-
1
forms 1 VIBRATION; then release the key.
02. Press and hold down key ■ again (for approx. 5
seconds), until the motor performs 4 SHORT
4
motions; then release the key.
03. Press and hold down key ■ again (for approx. 5
seconds), until the motor performs 4 LONG
3
motions (= RDC function activated); then
release the key.
English – 13