Description Of The Functions - Nice MINDY A6-A6F Mode D'emploi

There is a second set of dip-switches with other functions in the A700F version:
Switch 11
Switch 12
Switch 13
Switch 14
Switch 15
Switch 16
Switch 17
Switch 18
Switch 19
Switch 20
•
We wish to remind you that the functions that are possible only in certain cases are indicated with the notes between the symbols
"<>" following the description of the function.
•
Of course, if a dip-switch is "OFF" the function described will not be activated.

4.2) DESCRIPTION OF THE FUNCTIONS:

Here is a brief description of the functions that can be added by switching the relative dip-switch "ON".
Switches 1-2:
In the "Manual" functioning mode, the gate will move only as long as the key to command it is held down.
In the "Semiautomatic" functioning mode a command pulse is enough to carry out the whole movement up to the mechanical stop
or until the limit switch triggers. In the "Automatic" functioning mode an opening manoeuvre is followed by a pause and then a
closing manoeuvre.
The "Always Closes" function comes into play subsequent to a temporary power cut; if the gate is open a closing manoeuvre starts
automatically preceded by 5 seconds of preflashing.
Switch 3:
In the Condominium functioning mode, once an opening manoeuvre has started it cannot be interrupted by other command pulses
on STEP-BY-STEP or OPEN until the gate has finished opening. During a closing manoeuvre, a new command pulse will stop the
gate and reverse the direction, opening the gate.
Switch 4:
With a command pulse first of all flashing is activated followed by movement 5 seconds later (2 seconds if on manual).
Switch 5:
With this function the gate can be kept open only for the length of time needed for transit; in fact, it will close automatically always
5 seconds after the last object has passed by the Photocell or Photocell 1, irrespective of the programmed Pause Time.
Switch 6:
This is the only function that makes the photoelectric cells PHOTOCELL and PHOTOCELL 1 different. As a rule the safety devices
PHOTOCELL and PHOTOCELL 1 will only trigger in the closing manoeuvre, having no effect whatsoever in the opening
manoeuvre.
If dip-switch No. 6 is turned "ON", the PHOTOCELL will continue triggering only in the closing manoeuvre but PHOTOCELL 1 will
trigger also in the opening manoeuvre, causing an interruption in the movement. In the semiautomatic or automatic mode,
movement will restart after the last object has passed by PHOTOCELL 1
This is useful to stop the gate in the opening manoeuvre when, for example, a vehicle nears the gate from the inside, which is in
the direction of the manoeuvre, without stopping movement when the vehicle nears the gate from the outside.
Switch 7:
Movement starts gradually, sending an increasing force to the motor forming a ramp that lasts about 1 second; this guarantees a
jolt-free start. (Not recommended on METRO gear motor).
On = Positioning function <
On = Flashing also in Pause <
On = Pressure holding
On = Gate Open Indicator with proportional flashing
On = Phototest operation
On = Photocell and Photocell 1 also in opening
On = Photocell and Photocell 1 at start of the opening manoeuvre
On = Misses STOP in opening
On = Misses STOP in closing
On = CLOSE becomes PEDESTRIAN OPEN
Off Off = "Manual" movement (Man Present)
On Off = "Semiautomatic" movement
Off On = "Automatic" movement (Automatic Closing)
On On = "Automatic+Always Closes" movement
On = Condominium function (not available in the Manual mode)
On = Preflashing
On = Recloses straight after Photocell (only if in the Automatic mode)
On = Photocell 1 also in opening
On = Gradual start
only with the aid of the limit switch
>
Only in the Automatic mode
English
>
31