Automatic Open/Close Function In The Event Of Rain - Nice Free-Max Instructions Et Avertissements Pour L'installation Et L'utilisation

03. Press and hold down key ■ until the motor per-
forms 3 LONG motions; then release the key
3
exactly on the third movement.
04. Press and hold key ▼ until the motor performs
3 LONG motions; then release the key exactly
3
on the third movement.
05. (within the next 2 seconds) Press keys ▼ and ▲
simultaneously, and then release them.
5
After a few seconds the motor performs 5 LONG
motions (= Memory cleared).
If the Transmitter is not memorised, proceed as follows:
A. Disconnect the power supply (if connected) and
(5")
connect again the tubular motor to the power
1
off on
supply. Within the next 60 seconds, press and
hold down key ■ (for approx. 5 seconds), until
the motor performs 1 VIBRATION; then release
the key.
B. (within the next 5 seconds) Disconnect the
power supply.
off
(5"...)
C. Power the motor again: the previous proce-
01.
dure, from point 01 to point 05, must be per-
02.
on
(60"...)
formed within 60 seconds from turning on the
....
power supply.
AUTOMATIC OPEN/CLOSE FUNCTION IN
13
THE EVENT OF RAIN
✔
For AWNINGS: For ROLLER SHUTTERS:
If a Climatic rain Sensor is remotely connected to Free-Max, the automatic
awning behaviour in the event of rain can be programmed by selecting one of
the following options: "awning open" or "awning closed" (Note – consult the
sensor manual as well).
01. Press and hold down key ■ (for approx. 5 sec-
(5")
onds), until the motor performs 1 VIBRATION;
1
then release the key.
02. Press key ■ again 3 times.
03. (within the next 5 seconds) Press 1 of the fol-
0
lowing keys once to indicate the position the
awning must automatically take in the event of
1
rain:
• ▼ key (= awning open, position "1");
• ▲ key (= awning closed, position "0").
3
At this point the motor performs 3 LONG
motions (= position memorised).
English – 17