Environmental Conditions; Materials; Electromagnetic Compliance (Emc) Information - Invacare Birdie Manuel D'utilisation

Invacare® Birdie®
* depending on the configuration

10.3 Environmental conditions

Storage and
transportation
Temperature -10°C to +50°C
Relative humidity 20% to 90% at 30°C, not condensing
Atmospheric
pressure
Allow the product to reach operation temperature
before usage:
• Warming up from minimum storage temperature
might take more than 30 minutes.
• Cooling down from maximum storage
temperature might take more than 5 minutes.

10.4 Materials

Component
Base, legs, mast and boom
Hanger bar
Actuator housing, hand
control, mast protector,
casters and other plastic
parts
Carabiner, bolts and nuts
46
Operation
+5°C to +40°C
800 hPa to 1060 hPa
Material
Steel, powder coated
Steel, powder coated and
foam
material according to
marking (PA, PP, PE)
Steel, rust protected,
zinc-plated
10.5 Electromagnetic compliance (EMC)
information
Medical Electrical Equipment needs to be installed and used
according to the EMC information in this manual.
This equipment has been tested and found to comply
with EMC limits specified by IEC/EN 60601-1-2 for Class B
equipment.
Portable and mobile RF communications equipment can
affect the operation of this equipment.
Other devices may experience interference from even the
low levels of electromagnetic emissions permitted by the
above standard. To determine if the emission from the lift
is causing the interference, run and stop running the lift.
If the interference with the other device operation stops,
then the lift is causing the interference. In such rare cases,
interference may be reduced or corrected by the following:
• Reposition, relocate, or increase the separation between
the devices.
1575480-E