Replacing The Flexible Plate; Replacing The Packing Wheels Scraper - Checchi & Magli BABY COMPACT Manuel D'utilisation Et D'entretien

Replacing the packing wheels scraper

For this operation, proceed as outlined below.
1) Remove the lock pin (A).
2) Remove the circlip (B).
3) Remove the washer (C).
4) Unscrew the screw (D).
5) Slide the scraper off the shaft.
6) Fit the new scraper.
7) Tighten the screw (D).
8) Fit the washer (C) followed by the circlip (B).
9) Insert the lock pin (A).

Replacing the flexible plate

UN41-0686BO
For this operation, proceed as outlined below.
1) Loosen the wing nut (A).
2) Turn the lock lever (B).
3) Push the share forwards and turn it so it is facing
downwards.
4) Release the spring (C).
5) Unscrew the screws (D).
6) Remove the flexible plate (E).
7) Fit the new flexible plate in position.
8) Tighten the screws (D).
9) Attach the spring (C).
10) Make sure the flexible plate is centred (see "Adjust-
English language
INFORMATION CONCERNING REPLACEMENTS
A
B
UN41-0685BO
B
ing the flexible plate centring").
11) Check the position of the flexible plate with respect
to the share (see "Adjusting the flexible plate posi-
tion").
12) Refit the share in the work position.
13) Check that the Plant Control device is inside the
share.
14) Make sure that the share is secured in place with the
lock lever (B).
15) Tighten the wing bolt (A).
NOTICE
Check that the plant control plate is inside the share.
40
8
D
B
C A
D
E
C
Use and maintenance