Adjusting The Support For The Mulch Sheet Roll-Idler Roller - Checchi & Magli AL-S14 PLUS Manuel D'utilisation Et D'entretien

Adjusting the camber_______________________________________________________________________________
Alter the camber to move the tyre away from the edge of
the mulch sheet in small movements.
To adjust the camber, proceed as outlined below.
1) Loosen the screws (A).
2) Alter the wheel angle as required.
3) Tighten the screws (A).
Adjusting the pressure of the wheels on the mulch sheet__________________________________________________
To adjust the wheel pressure, proceed as outlined be-
low.
1) Turn the handwheel (A) to increase or decrease the
wheel pressure on the mulch sheet.

Adjusting the support for the mulch sheet roll-idler roller

Adjust the support so that the idler roller (A) is 10 to 15
cm off the ground during the working stage.
To adjust the roll support, proceed as outlined below.
1) Lift the roll brake.
2) Place the roll in use on the spare roll supports and
keep the mulch sheet taut.
3) Prop up the support suitably to prevent it from fall-
ing to the ground and causing injury.
4) Unscrew the bolts (B) on both sides of the machine.
5) Raise or lower the support as required and align the
holes in the support with those in the frame.
6) Tighten the bolts (B) on both sides of the machine.
7) Once the adjustments are complete, place the roll
back in its original position, making sure it is in the
centre (see "Loading the mulch sheet roll").
8) Lower the roll brake.
9) Adjust the unwinding tension of the mulch sheet ac-
cordingly (see "Adjusting the mulch sheet unrolling
tension").
English language
ADJUSTMENT INFORMATION
UN41-0313LI
UN41-0311LI
UN41-0316LI
24
A
B
A
Use and maintenance
5