Checchi & Magli AL-S14 PLUS Manuel D'utilisation Et D'entretien page 69

The hoeing shares are used to make furrows in the soil
where the edges of the mulch sheet will be laid and
which are adjustable in terms of width, depth, and in-
clination.
To adjust the hoeing shares, proceed as outlined below.
1) Loosen the screw (A).
2) Place the shares at the distance from the edge of the
mulch sheet (B) shown in the figure.
Adjust the shares as required, in the way described.
- Raise or lower the shares to increase or decrease the
depth of the furrow.
Adjusting the ridging disks
The ridging disks are used to cover the edges of the plastic mulch sheet with soil.
Adjusting the distance of the disks from the edge of the mulch sheet ________________________________________
UN41-0247IH
1 - Mulch sheet roll
2 - Ridging disks
D - Mulch sheets to be laid on the bed
To adjust the disk, proceed as outlined below.
1) Use the handwheel (H) to slacken off spring ten-
sion.
2) Release the spring (B) from the support (F).
3) Loosen the screws (A).
4) Move the arm (C) so that the disk is as far away from
the edge of the mulch sheet (D) as stated in the fig-
ure.
English language
ADJUSTMENT INFORMATION
- Alter the angle of the shares to increase or decrease
the width of the furrow.
3) Tighten the screw (A).
If the pointer (D) prevents the share lowering as desired,
proceed as described.
1) Loosen the screw (C) and lift the pointer (D) without
turning it. The pointer must not be turned as it would
desynchronise the initial inclination of the share in
relation to the gauge scale (E).
2) Tighten the screw (C).
Repeat the same procedure for the other share.
1
1
2
D
Decide whether to adjust the disk depth, tilt, and
shift (see "Adjusting the depth, tilt, and longitudinal
displacement of the disk").
5) Tighten the screws (A).
6) Loosen the screw (E).
7) Move the support (F) and place it in position with
the arm (C).
Check that the stroke limit (G) tallies with the arm.
8) Tighten the screw (E).
9) Attach the spring to the support (F).
10) Use the handwheel (H) to tension the spring.
Repeat the same procedure for the other disk.
21
5
14-18 cm
30 cm
Use and maintenance