Checchi & Magli BABY COMPACT Manuel D'utilisation Et D'entretien page 77

Changing the transmission ratio (Rapid Shift)
WARNING
Switch off the tractor engine, remove the ignition
key, and store in a safe place to prevent an accident
during the change of the transmission ratio.
B
UN41-0679BO
For this operation, proceed as outlined below.
1) Unscrew the knob (A).
2) Remove the casing (B).
3) Loosen the knob (C).
4) Push lever (D) to slacken the chain.
5) Move the chain (E) on the pair of pinions correspond-
Seat positioning
Poor work posture will tire the operator and could lead
to mistakes being made; therefore, before starting work,
adjust the seat and secure it in the position that offers
maximum comfort.
A) Lever: this is used to adjust the seat lengthways.
Release the lever and then move the seat forwards or
backwards.
Secure the seat in the right position using the lever.
B) Lever: this is used to adjust the seat tilt.
Release the lever and then tilt the seat forwards or
backwards.
Secure the seat in the right position using the lever.
C) Screws: these are used to adjust the seat height.
Unscrew the screws and then raiser or lower the
seat.
Tighten the screws to secure the seat in the right po-
sition.
English language
INFORMATION FOR USE
A
NOTICE
The aim of the change of the transmission ratio is to
obtain the required plant spacing.
See the "Adjusting the plant spacing" chapter to se-
lect the pair of pinions to be used from the range of
possible combinations.
E
C
ing to the plant spacing necessary to plant the seed-
ling.
6) Pull the lever (D) and tighten the chain adequately.
7) Tighten the knob (C).
8) Fit the casing (B).
9) Tighten the knob (A).
UN41-0069CF
29
D
B
C
A
Use and maintenance
6