Lifting And Transporting The Work Vehicle; Loading, Transporting And Unloading The Work Vehicle/Tractor Assembly - Checchi & Magli BABY COMPACT Manuel D'utilisation Et D'entretien

Lifting and transporting the work vehicle

WARNING
During lifting watch out for the load swinging, as
the hook-up point is never perfectly at the centre of
gravity.
D
C
B
UN41-0064CF
For this operation, proceed as outlined below.
1) Use the specific tool (A) provided with the work vehi-
cle for lifting.
2) Strap up the work vehicle as shown in the figure.
3) Check that the pin (B) is secured by the lock pin (C)
and that the chains are fastened stably to the frame
(D).

Loading, transporting and unloading the work vehicle/tractor assembly

The loading / unloading of the work vehicle / tractor as-
sembly must be carried out using appropriate means of
transport equipped with suitable ramps.
WARNING
Before getting the machine on and off the transport
means clean the ramps and truck bed accurately.
Where the ramps meet the truck bed there is a dan-
gerous bump so move the machine very carefully
over this point.
English language
INFORMATION CONCERNING HANDLING AND INSTALLATION
The lifting procedure shown applies for all the work ve-
hicle models specified in the manual.
For models BABY COMPACT/3 - BABY COMPACT/5, the
seat must be removed to allow the lifting means to be
fitted.
The illustration shows the work vehicle with three plant-
ing units.
A
4) Lift the work vehicle and place it on the means of
transport.
5) The work vehicle to the means of transport with
wedges and ropes.
6) Affix the relative signalling signs to any parts jutting
out from the means of transport.
For this operation, proceed as outlined below.
1) Start the tractor and lift the work vehicle as far off the
ground as is permitted.
2) Get into the means of transport from the tractor's
driving seat.
3) Lower the work vehicle onto the truck bed.
4) Off the tractor engine and engage the parking
brake.
5) Anchor the work vehicle and the tractor to the means
of transport with wedges and ropes.
6) Affix the relative signalling signs to any parts jutting
out from the means of transport.
11
4
D
Use and maintenance