Checchi & Magli BABY COMPACT Manuel D'utilisation Et D'entretien page 64

Adjusting the row spacing
WARNING
Secure the work vehicle in position (lifted off the
ground) with external means (trestles, etc.).
Do not stand under the hoisted machine unless it is
suitably secured in position.
Adjust the gap between the planting units to obtain
the row spacing required (for distances envisaged, see
A
B
A
UN41-0666BO
To adjust the row spacing, proceed as outlined below.
1) Lift the work vehicle slightly off the ground.
2) Loosen the nuts (A).
3) Slide the planting unit along the frame (B) until the
required plating spacing is obtained.
Adjust the planting units so that the seedlings are
kept (C) cm 10 - 12 away from tractor wheel.
English language
ADJUSTMENT INFORMATION
"Technical characteristics" schedule).
Keep the minimum distance stated on the illustration
between the seedlings and the tractor wheels.
Adjust the seat position accordingly.
A
A
4) Tighten the nuts (A).
5) Loosen the nuts (D).
6) Move the seats to the midline of the respective plant-
7) Tighten the nuts (D).
16
D
10-12 10-12
C C
cm cm
ing unit.
5
10-12 10-12
C C C
cm cm
Use and maintenance