Grillo Climber CL 7.13 Mode D'emploi Et Maintenance page 15

CAUSE
– No petrol flow
– Fault in ignition system
– Speed too high for cutting height
– Cutting deck not parallel to ground
– Blades fault
– Blades unbalanced
– Fastenings are loose
ELECTRICAL SYSTEM
The electrical system is protected by a fuse which cuts out the entire electrical system if blown.
After finding and repairing the fault, replace the fuse with another of the same rating.
Never replace the fuse with one of a different rating.
The electrical system fuses are on the left-hand side of the steering wheel (fig. 23).
If the problems persist after all the procedures described above have been carried out, contact the Authorised After-
Sales Service Centre.
Never attempt to make difficult repairs unless you have the necessary equipment and technical expertise.
IMPORTANT!
– Take care not to reverse the battery polarity.
– Never operate the mower without the battery, since it is equipped with a charge regulator.
– Take care not to cause short-circuits.
THE MACHINE DOES NOT REMAIN IN NEUTRAL
Adjust the device (fig. 24) by loosening the counter-nut and acting on the central screws.
FORWARD LEVER
To adjust the forward and reverse travel speeds, use the screws (A, fig. 25) if the forward lever automatically returns
to zero adjust the self-locking nut (B, fig. 25).
PROBLEM
Starter motor turns over but engine does not start
Drop in engine performance during cutting
Uneven cutting
Vibrations during operation
REMEDY
– Check that the choke has been activated (if engine is
cold)
– Check petrol level in tank
– Check wiring of carburettor opening control
– Check petrol filter (and change if necessary)
– Check that the vent on the tank cap is not blocked
– Check that the caps of the sparkplugs are correctly
fastened
– Check that the electrodes are clean and at the correct
distance apart.
– Reduce speed
– Raise cutting deck by a few notches
– Check tyre pressure
– Level off the deck
– Check that the blades are correctly mounted
– Sharpen or change the blades
– Check the tension of the deck motor belt
– Balance blades or replace if damaged
– Check and fasten the blade fixing screws as well as
the fixing screws of the engine and chassis.
15