Publicité
Les langues disponibles
Les langues disponibles
AILERON AND FLAP SERVO INSTALLATION
1.
Remove the servo cover partially from the wing.
2.
Mark the cover with an arrow facing the leading edge.
This will help orient the cover after the servo has been
installed.
3.
Check that the servo mount is glued securely to the
servo cover. If the mount is not secure, use a small
amount of medium CA or epoxy to make sure the mount
is securely fastened to the servo cover.
4.
Use a toothpick or hobby knife to puncture the covering
at the screw holes that will secure the cover to the wing.
5.
Place the cover back into position using the arrow made
earlier to ensure their correct orientation. Use a pin vise
and 1/16-inch (1.5mm) drill bit to drill the mounts for the
servo covers.
Van's RV-4 30cc
1.
2.
3.
4.
5.
6.
Thread a #2 x 3/8-inch sheet metal screw into each
hole using a #1 Phillips screwdriver. Remove the screws
before proceeding.
7.
Apply a small amount of thin CA to harden the threads
made in the previous step. Allow the CA to fully cure
before installing the aileron servo cover.
8.
Install the grommets and brass eyelets in the servos.
Follow any instructions included with the servo. Prepare
both the fl ap and aileron servos at this time.
9.
Secure an 18-inch (460mm) servo extension to the
tip servo using a commercially available fastener
(SPMA3054).
10. Fit the servo between the servo mounting tabs in the
aileron servo tray. The servo arm will be centered in the
slot. Mark the locations for the servo mounting screws
using a pencil, then remove the servo.
11
6.
7.
8.
9.
10.
EN
Publicité
