Error Messages / Troubleshooting; Technical Specifications - Beurer BC 30 Mode D'emploi

• If the unit is stored near freezing, allow it to acclimate to
room temperature before use.
• Always store the unit in its storage case after use.
• This unit may not meet its performance specifications if
stored or used outside of the temperature and humidity
ranges (see section "10. Technical Specifications").
• Use the unit consistent with the instruction provided in
this manual.

9. Error messages / troubleshooting

In the event of errors, the error message
the display.
Error messages may appear in the following cases:
• it was not possible to record the pulse:
• you move or speak during the measurement:
• the cuff is fastened too tightly or loosely:
• errors occur during the measurement:
• the pump pressure is higher than 300 mmHg:
• the batteries are almost empty
In such cases, repeat the measurement. Ensure that you
do not move or speak.
If necessary, reinsert or replace the batteries.
NOTE:
If the unit still does not work, contact customer service at
1-800-536-0366.

10. Technical Specifications

Model no.
Type
Measurement
method
Measurement range Cuff pressure 0-300 mmHg,
appears on
Display accuracy
;
;
Measurement
;
inaccuracy
;
;
Memory
.
Dimensions
Weight
Cuff size
22
BC 30
BC 30/1
Oscillometric, non-invasive blood
pressure measurement on the wrist
systolic 50-250 mmHg,
diastolic 30-200 mmHg,
pulse 40-180 beats /minute
Systolic ± 3 mmHg,
diastolic ± 3 mmHg,
pulse ± 5 % of the value shown
Max. permissible standard devia-
tion according to clinical testing:
systolic 8 mmHg /diastolic 8 mmHg
2x 60 memory spaces
2.75 in (L) x 2.8 in (W) x 1.1 in (H)
(70 mm L x 72 mm W x 27.5 mm H)
Approximately 3.7 oz (105 g)
(without battery)
5.3 in - 7.6 in (13.5 – 19.5 cm)