Positioning Cuff - Beurer BC 30 Mode D'emploi

Masquer les pouces Voir aussi pour BC 30:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

• Please contact your physician about the specific risks
of cuff pressure in your specific case.
CAUTION:
• The device should not be used when your arm has been
wounded/injuried or when a catheter has been inserted.
Such use may result in injury.
• Remove any kind of wrist jewelry or the like before tak-
ing a measurement. This could cause bruises.
• Do not place the wrist cuff over heavy clothing (e.g. a
jacket or sweater sleeve) as the blood pressure monitor
will not be able to take a proper measurement and there
is an elevated danger of acquiring hematoma or skin
marks during the course of the measurement.
• In case the cuff does not stop inflating, interrupt the
measurement by pressing the start/stop button and
open the cuff at once.
• When applying the arm cuff, make sure there are no
wrinkles in the cuff. This could cause bruises.
• Do not exert any kind of pressure on the tube during
measurement, e.g. laying your arms or any other object
on the tube. This could cause incorrect measurements.
• Blood pressure measurements can lead to temporary
marks on the skin at the site of the cuff placement. This
is especially the case in high repetition rates, in hyper-
tonic patients and in patients with weak pulses. In rare
cases a mark may persist for a couple of days. Please
contact your physician about these specific risks of cuff
pressure in your specific case.
• For hygienic reasons the cuff is intended only for the
use by one person.
• It is recommended that the cuff be cleaned after every
200th use.
• It is recommended that the cuff be disinfected twice a
week using a cloth that is lightly moistened with ethyl
alcohol (75 – 90 %); then allowed to air dry.

6.1 Positioning cuff

NOTE:
Always properly position the wrist cuff on the wrist at heart
level, according to the following instructions.
Fit the cuff round your bare left wrist. Do not place the wrist
cuff over heavy clothing (e.g. a jacket or sweater sleeve) as
the blood pressure monitor will not be able to take a proper
measurement. Blood circulation in the arm should not be
restricted by tight clothing or other objects.
1. Remove any clothing or jewelry from your left lower arm.
Ensure that blood circulation in the arm is not restricted
by tight clothing or similar items.
2. Place the unit on the inside of your wrist with your palm
facing upwards.
3. Fasten the cuff with the hook-and-loop strip so that the
upper edge of the device is positioned approx. 0.4 in
(1 cm) below the bottom of your hand. The cuff must
15

Publicité

Table des Matières
loading

Table des Matières