A Front Wheel Positions; Assembling The Mulching Cover - Eurosystems P130 Traduction De La Notice Originale

(9), the two screws (10) and the two nuts
(11) from the tool bag (3).
Fig. C): push the handle (12) through the
bushings (13) so that the pin (14) goes into
the parking position hole (pos. B). First in-
stall the spring and then the spacer in the
handle and push it to flatten the spring so
that the cotter pin is completely inserted
into the hole (15). Bend the split pin to lock
it (16): make sure it does not come out of
the spacer so that it does not interfere
with the cover, which must be fixed by the
two screws and two nuts in the holes (17).
Pull the handle, turn it and let it go to ensu-
re that it goes into the three holes A, B, C.
5.1.A. FRONT WHEEL POSITIONS
[ fig. 08]
Pos. A)
Transfer: for long movements or raised cut
(in the bottom hole).
Pos. B)
Parking: for coupling/uncoupling
machine (in the middle hole) and storage.
Pos. C)
Overturning: for cutting grass so as to
avoid obstructions (in the top hole).
5.2. ASSEMBLING THE BALLAST
[ fig. 09]
For very high or thick grass or steep
slopes, one ballast (1=4 kg) or two
ballasts (2=8 kg) may need to be mounted.
To assemble one ballast: place it on the
flanged pipe (3) and fasten it with the
short M8 screw (4) and the M8 nut (5). To
assemble two ballasts: place them on the
flanged pipe and fasten them both with the
long M8 screw (6) and the M8 nut.
5.3. ASSEMBLING THE MULCHING
COVER [ fig. 10]
If you want to finely shred the grass,
you need to assemble the cover (1) by
inserting the 4 screws (2) into the holes
(3) from the bottom upwards and screwing
on the 4 nuts (4) to block them.
To take the cover off, unscrew the 4 nuts
and push it downwards through the holes.
5.4. ATTACHING THE TOOL/
ACCESSORY
the The accessory must be on the ground, ho-
rizontal and with the wheel in position "B":
• Make sure that the machine's engine
is off;
• Make sure that the PTO lever [22] is
in the neutral
• Hold the handle (12), pull it outwards,
turn it until the pin clicks into the hole
in pos. B and release. The wheel must
[ fig. 11, 11A, 12 and 12A]
position;
EN-9