Lifting; Handling; Instructions For Use; Front Wheel Positions - Eurosystems P130 Mode D'emploi

base of the pallet and remove it com-
pletely by raising it;
• Cut any ties on the bottom;

4.3. LIFTING

[ fig. 01]
DANGER!
Only use systems, devices and instru-
ments that are suitable for lifting mass-
es that are equal or above what is indi-
cated in the "Accessory Specifications"
chapter.
DANGER!
Do not walk or remain under moving
loads.
ATTENTION!
Do not use lifting systems or devices
with sharp parts.
DANGER!
Before using lifting ropes or bands,
check how strong they are. In case of
damage, even partial they must be re-
placed.
ATTENTION!
Never lift the machine when it is con-
nected to an accessory or tool.
Lift the accessory with a hoist or similar
equipment with a minimum capacity as
EN-8
specified in the "Accessory specifications"
chapter. Attach as shown in
(hooking bars).

4.4. HANDLING

Move the accessory only when attached
to the P130 machine.
If you have a van equipped with a lifting
crane, follow the
indicated in the previous paragraph.
DANGER!
Never lift the accessory when attached
to the machine.

5. INSTRUCTIONS FOR USE

DANGER!
Before using the machine read and un-
derstand carefully this operation and
maintenance manual and the machine's
operation and maintenance manual.

5.1. FRONT WHEEL POSITIONS

[ fig. 05]
Pos. A)
Transfer : for long transfer or lifted cut.
Pos. B)
Stopping : for coupling / uncoupling to the
machine and storage.
[13 , fig. 01] .
lifting instructions