Saturation Display; Lighting; Button Tone - Gaggenau AC270101 Notice D'utilisation Et De Montage

Operating the appliance
en
If the sensor control responds too strongly or not
enough, it can be changed accordingly:
1 With the appliance switched off, press and hold the
# and r buttons for approximately 3 seconds.
Press the @ or A button to change the sensor
2
control setting.
Press and hold the # and r buttons for
3
approximately 3 seconds to save the setting or wait
for around 10 seconds until the setting is saved
automatically.
A signal tone will sound.
Note: Press the # button to cancel the setting.

Saturation display

If the grease filter or odour filter is saturated, the
corresponding LEDs will flash and a repeated signal
tone will sound after the appliance has been switched
off:
▯
Grease filter: LED 1 flashes
▯
Odour filter: LED 2 flashes
▯
Grease filter and odour filter: LEDs 1 and 2 flash
The grease filters should now be cleaned or the odour
filter needs to be replaced. ~
maintenance" on page 38
The saturation indicators can be reset while they are
flashing. To do this, press the œ button.
Settings for using the odour filter
1 When the appliance is switched off, press and hold
the # and œ buttons for approx. 3 seconds.
The LED for the currently active filter setting lights
up on the appliance.
Press the @ button/A button until LED 2 for
2
circulating-air mode (filter cannot be regenerated)
lights up on the appliance.
Press the @ button/ A button until LED 3 for
3
circulating-air mode (filter can be regenerated)
lights up on the appliance.
Press the @ button/A button until LED 1 on the
4
appliance for the electronic controller is switched
back to operation without the air recirculation filter.
Press and hold the # and œ buttons for approx.
5
3 seconds to save the setting or wait for around
10 seconds until the setting is saved automatically.
A signal tone will sound.
Note: Press the # button to cancel the setting.
34
"Cleaning and

Lighting

The lighting can be switched on and off independently
of the fan.
Press the B button.
Setting the brightness
Press and hold the B button for approx. 1 second until
the required brightness is reached.
Note: Colour temperature settings are available in the
Home Connect app provided the appliance has this
function.

Button tone

Switching on or off
Note: Only button tones can be switched on and off.
Signal tones on the appliance cannot be switched off.
1 When the appliance is switched off, press and hold
the # and A buttons for approx. 3 seconds.
The LED in the currently selected setting lights up.
Press the @ or A button to change the setting.
2
The button tones are switched on if LED 1 lights up
on the appliance.
The button tones are switched off if LED 2 lights up
on the appliance.
Press and hold the # and A buttons for approx.
3
3 seconds to save the setting or wait for around
10 seconds until the setting is saved automatically.
A signal tone will sound.
Note: Press the # button to cancel the setting.