Gaggenau AC270101 Notice D'utilisation Et De Montage page 48

Installation
en
5 Thread the cables through the openings of the
frame cover.
6 Undo the strain relief on the cable on the appliance
and pull out the cable.
7 Thread the cable on the appliance through the
opening in the frame cover and use the strain relief
supplied to secure it.
Caution!
There is a risk of damage to the appliance if the
cable is coiled up. Always secure the cable firmly
using the strain relief so that it does not coil up fully
in the appliance.
8 Remove the strain relief fitted at the factory.
Note: Keep the strain relief and do not throw it
away.
9 Thread four cables into the cable tensioner and
apply equal tension.
Note: Never shorten the cables.
48
10 Adjust the cables if necessary. To do this, relieve
the load on the appliance, loosen the cable
tensioner and push it upwards.
11 Thread the four enclosed cable clamps and secure
in place approx. 2 cm in front of the cable tensioner.
Note: Tighten the screws by hand.
12 Align the appliance using a spirit level.
13 Place a scissor lift table or another suitable device
under the appliance.
The appliance hangs on the cables from the ceiling.
14 Pull out the cable on the appliance completely.
Caution!
There is a risk of damage to the appliance if the
cable is coiled up. Hold the cable so that it does
not coil up fully in the appliance.