Sensor Control; Saturation Display; Lighting; Audible Signal - Gaggenau AW 2 Séries Notice D'utilisation Et De Montage

Sensor control

In automatic mode, the sensor in the extractor hood detects the
intensity of the cooking and roasting odours. Depending on
the sensor setting, the fan automatically switches itself to
another fan setting.
Possible sensor settings:
Default sensitivity setting: 3 (fan setting 3)
Lowest sensitivity setting: 1 (fan setting 1)
If the sensor controller responds too strongly or not enough, it
can be changed accordingly:
1
2
3

Saturation display

If the metal grease filters or activated charcoal filter are/is
saturated, the corresponding symbols will flash once the
appliance has been switched off:
▯ œ
Metal grease filters:
▯
Activated charcoal filter:
▯
Regenerative activated charcoal filter:
If you have not yet done so, the metal grease filters should now
be cleaned or the activated charcoal filter replaced.
~ Cleaning and maintenance
œ
œ
Ò
r
Ò
r
and 1
œ
and 2
œ
and 3
œ
Switching over the display for air recirculation mode
For air recirculation mode, the electronic controller must be
switched over accordingly:
▯
The extractor hood must be connected and switched off.
▯
▯
▯
▯ œ

Lighting

The lighting can be switched on and off independently of the
fan.
ž
Setting the brightness
ž

Audible signal

Switching on
#
Ò
Switching off
#
Ò
Operating the appliance
œ
œ
œ
œ
œ
# Ò
# Ò
en